Installation - RV Barbuddy

Parts List 1 - (2)Each - Eaz Lift/Draw Tite Bar Buddytm bracket (Click here for Reese Model instructions.) 2 - (2)Each - Bar Buddytm clamp bar 3 - (4)Each - 5/16-18 stainless steel set screw 4 - (4)Each - 5/32 diameter rivets 5 - (1)Each - 5/32 hex key
Step 1. Slide the Bar Buddytm bracket up over the 'A' portion of your trailer's frame from the bottom.
Step 2. Insert the Bar Buddytm clamp bar through the rectangular hole in the Bar Buddytm bracket.
Step 3. Insert the 5/16-18 set screws into the threaded holes in the clamp bar. Tighten each set screw until snug, then tighten each screw 1/4 turn at a time until tight.
Step 4. (Optional) Insert the rivets into the hex in the set screws. A light tap with a hammer will tighten the rivets for a secure installation. The rivets may be removed with a 5/32" drill if you need to remove your Bar Buddytm.
You are now ready to safely and securely store your spring bars by sliding them into Bar Buddytm at a 90 degree angle and swinging them toward the front of the trailer. Lock the chains with a padlock and your bars are secure.